Floor Coating Services

How these systems differ

Almost every commercial floor in Northwest Ohio is one of four things: an epoxy build, a polyaspartic or urethane topcoat over an epoxy base, a urethane cement mortar, or a polished slab with no coating at all. The decorative variations sit on top of those four, and the industrial variations are mostly a question of thickness and resin chemistry.

Epoxy is the general-purpose answer and the best value for most warehouse, shop and storage floors. It is hard, it bonds well to a properly prepared slab, and it carries flake or quartz for appearance and traction. It is rigid, though, which is why it is the wrong choice anywhere the floor sees hot liquid, steam cleaning or wide temperature swings.

Urethane cement is the answer in those wash-down environments. It expands and contracts at close to the same rate as concrete, so it stays attached through thermal cycling that would pull a rigid epoxy off the slab within a year. It costs more and it does not look decorative, which is a fair trade in a kitchen or a brewhouse.

Polished concrete is not a coating at all. The slab is ground, chemically densified and honed until the surface itself is hard and reflective. There is no film to delaminate, which makes it the lowest-maintenance option over a long horizon, but it offers little chemical resistance and it exposes every patch and crack in the original pour.

The choice that matters more than the product

Whichever system goes down, the preparation underneath it determines how long it lasts. A premium coating applied to an unprofiled slab will fail faster than a budget system applied to a properly shot-blasted one. That is not a marketing position, it is the single most consistent finding in commercial floor failure analysis, and it is why every page in this section describes the prep method alongside the product.